Vette Homepage

Chevrolet Corvette Interior Rear Seat Floor Glassed

With a paint brush we first applied resin to the bonding areas, and then thoroughly soaked a piece of the fiberglass matting with resin, and bridged the two mating surfaces. We did this the entire perimeter of the rear well. As the resin starts to dry you may need to pat the air bubbles out with your paint brush. The mat will lay flat, and be hardly noticeable.
The LAZARUS Project: PART II

 With a paint brush we first applied resin to the bonding areas, and then thoroughly soaked a piece of the fiberglass matting with resin, and bridged the two mating surfaces. We did this the entire perimeter of the rear well. As the resin starts to dry you may need to pat the air bubbles out with your paint brush. The mat will lay flat, and be hardly noticeable.  View Related Article

 

 

Get Adobe Flash player

Car Research Guide
Source Interlink Media © 2008 Vette Web,
Source Interlink Media
All rights reserved. WEB-045