With the performance improvements for our C5 Corvette complete (if not yet tested), we decided it was time to update the car's image as well. And what better way to make a statement than with a graphic treatment that complements the Vette's upgraded dynamic capabilities?
When it comes to stripes and other visual enhancements, there are a number of different options available. Most of the Corvette mail-order catalogs offer packages that consist of precut decal appliques. Alternatively, you can have your local graphic designer prepare custom decals based on your own artistic concept. Another option is to have your stripe laid down with paint. Modern basecoat/clearcoat-system stripes can be sprayed over the top of the existing paint, or applied over the base and sealed beneath the clear. For this article, we chose to perform a custom application over our Corvette's existing finish.
As always, the painting process...
As always, the painting process begins with cleaning the target area with soap and water, then drying with unoiled compressed air. Finish with a degreaser to remove all remaining silicones, oils, and waxes.
Custom striping begins with laying out the design in tape. This "rough in" stage will allow you to familiarize yourself with the look of the stripes before you begin cleaning and sanding. Start by marking the centerline of the car with tape or a permanent marker; this will help you keep everything symmetrical. Next, rough-in your custom stripe with fine-line tape. If you're unhappy with the outcome, the tape will allow you to make any necessary corrections. Once you've perfected your design, snap a quick digital photo. Now you're ready to get to work.
As you follow along with us, keep in mind that there are two different techniques you can use for the final clearcoat process. The first is to clearcoat only the stripes themselves. This is the easier and quicker method, but it will leave an edge where the stripes meet the original paint. The second technique (the one we chose) includes clearcoating the entire hood and bumper. This procedure is more involved, but the result will be seamless. Remember, if you choose the first technique, you will need to lay down the stripes first and sand only the areas that will be painted.
The next step begins with...
The next step begins with wet-sanding the target area so the new product will adhere to it. This operation may be performed by hand, using P600- or P800-grit sandpaper. Alternatively, you can use a dual-action sander with a 3M interface pad and a P1000-grit sanding disk. We chose to sand the entire panel so that the application of paint and clearcoat would form a seamless edge. After sanding, clean the entire area again to remove any dust, debris, or moisture.
The license-plate cover is...
The license-plate cover is prepared in the same way as the car's body. We outlined the lettering inside the cover with special fine-line tape so it would remain red and contrast with the stripe.
Mark the centerline of the...
Mark the centerline of the car with tape or a permanent marker; this will help you keep everything symmetrical. If you use a marker, be sure to remove all traces of ink before you start painting.
Fine-line striping tape should...
Fine-line striping tape should be used for the stripes. This tape is easy to work with and will leave a sharper edge, resulting in less edge build-up and reduced paint "bleeding."
Use masking tape to fill in...
Use masking tape to fill in the area you've outlined. Make sure everything is even, including the corners.
Next, mask off the remaining...
Next, mask off the remaining areas that won't be painted. To keep from getting confused, just remember that the unmasked areas will form the stripes themselves.