The rack-and-pinion is then mounted to the frame brackets that were previously installed and torqued to the specified value (30 ft-lbs, in this case).
The next step is to bolt the tie rod bracket to the rack-and-pinion. The outer holes are positioned to the top of the rack.
At this point, our new rack unit is in place, and we're ready to get this baby hooked up.
The intermediate shaft support bearing can then be installed onto the remaining part of the assembly.
The Steeroids(tm) kit includes an assembly made up of a single U-joint, an intermediate shaft, and a double U-joint. The single U-joints is removed and installed onto the steering rack.
As seen here, the double U-joint connects to the factory steering column, while the intermediate shaft has been reconnected to the single U-joint. The support bearing bolts to the driver-side bracket.