It's True, Corvettes Get Rusty, Too. Here's How To Repair A Common Problem
We can hear it already. "How to repair rusty Corvettes? Corvettes are fiberglass and fiberglass doesn't rust!" Right-and wrong. The exterior body panels on Corvettes are fiberglass, or maybe a better way to say it is glass fiber-reinforced plastic, and these plastic panels will not, can not rust. On the other hand, all of those swoopy fiberglass panels are attached to steel inner structures, which are in-turn bolted to a steel frame. And steel rusts.
Corvette frames with rust-through problems, particularly '63-67 and '68-82 (probably due to the design of the side rails and the rear axle kick-up) are, unfortunately, relatively commonplace, especially in the Rust Belt regions. Nearly as prevalent, but hidden away beneath body panels and moldings, is severe corrosion of the steel (internal) windshield pillar and cowl side/door hinge structure on C3s. These structural pieces are nothing but stamped sheetmetal parts that have been spot-welded together to form the cowl sides and windshield framing. They're box sections with open centers, seem to be prone to leakage, and don't drain well. In other words, the perfect recipe for rust.
It must be a heartbreaker to have what you think is a nice, solid Stingray only to inadvertently discover, by having a windshield replaced or when removing molding for a fresh coat of paint, that your fiberglass-bodied car has structural body rot.
Nick Conti runs a high-end autobody and paint facility (Conti Custom Auto, 25500 Joy Blvd., Harrison Township, MI 48045, 586/954-1929) in the Detroit-area. Recently, a customer brought in a lean '71 Corvette coupe for a new exterior paint job. A good quality repaint requires removal of stuff like bumpers, grills, lights, emblems, and moldings-slapping masking tape over them is the shoddy and cheap way to do it. When they pulled the windshield moldings, it was immediately and readily apparent why the car had leaked around the windshield-portions of the inner, steel windshield frame were almost completely rusted away.
This doesn't necessarily mean the kiss of death for a nice old Vette. Since the corrosion had NOT spread into the cowl sides (the door hinge structure), extensive (and expensive) reconstruction or a complete restoration wouldn't be required. Nick was able to locate a solid and rust-free used C3 windshield frame from a local Corvette salvage yard, and that recycled part would allow him to affect a thorough, yet reasonably priced repair.
The keys to a successful repair of this sort are to take careful measurements of the original car, careful measurements of the replacement part(s), more careful measurements, neat and clean cuts, and top quality welding. The difference between a successful repair and total failure is accurate measurements. Close doesn't count; the windshield glass can't be forced back into a frame that's a fraction of an inch too short or angled steeper on one pillar than the other. Precise measuring and cuts, coupled with the labors of a skilled craftsman result in a top-quality repair job. Here's how it's done...